Description
The Currie LP60 rear axle for the Jeep Wrangler JK/JKU is the perfect direct bolt-in upgrade for multi-purpose commuters, Overlanders, and tow vehicles that also see off-road use.
The Currie LP60 features efficient low-pinion 60 gears, large 3.5-inch diameter axle tubes, and 40-spline axles to provide a massive upgrade in strength and reliability over the stock JK rear axle assembly. Additionally, the LP60 retains the factory wheel bolt pattern so that you can keep those nice wheels.
Details:
- Direct Bolt-in Fit for Wrangler JK/JKU
- Factory 65.375-Inch Width
- Heavy-Duty Low-Pinion Cast Center Section
- 3.5 x .375-inch Axle Tubes are Twice the Strength of the Stock Tubes
- Currie Extreme 40-Spline Axles
- Choice of Selectable Locker and Gear Ratio
- Currie Heavy-Gauge Laser Cut Brackets
- Pinion Angle Optimized for Stock Height up to 4" of Lift
- Currie Rock-Proof Nodular Iron Differential Cover
- Upgraded 1350 Pinion Yoke
- Satin Black Powder Coat for Long Lasting Protection
- Retains Stock 5x5” Wheel Bolt Pattern
- Retains the Factory JK Rear Brake Components
The Currie LP60 low-pinion rear axle for the 2007 and newer Wrangler JK/JKU is a direct bolt-in axle assembly with all required brackets and mounts in place. The vehicle's factory brakes will be retained and installed on the new LP60 axle. The factory driveshaft will require modification or replacement to accommodate the larger 60 series housing and 1350 series u-joint.
Notes
- ABS Sensors - The stock axle must be retained and installed on the Currie housing
- Driveshaft - A replacement driveshaft compatible with the larger 60 housing and 1350 yoke is required. Spicer PN 10113217 is recomended (verify manufacturer vehicle fitment)
- Brake Components - Retains the stock rear disk brake rotors or calipers; mounting brackets are designed to reuse the stock factory brake components from the vehicle.
- Wheel and Tire Size - 17-inch or larger wheels are required for proper clearance of the brake calipers. The maximum recommended tire size is 39-inches for semi-floating axles.
- Overall Width - Axle width is 65.375 inches (Factory stock) between wheel mounting surfaces
