Description
STEER SMARTS YETI XD™ "No Drill" Top Mount Draglink – Jeep JK Wrangler (2007–2018)
Upgrade your JK Wrangler’s steering without the hassle of drilling. The STEER SMARTS™ YETI XD™ "No Drill" Top Mount Draglink is the industry’s fastest and easiest way to flip your draglink, thanks to our patent-pending Reverse Taper Mount design.
Engineered using over 85 years of steering experience, the YETI XD series delivers unmatched strength, reliability, and trail-ready performance. This direct bolt-on system installs in minutes and works with your factory knuckle and pitman arm holes—no modifications needed.
Key Features
YETI XD Draglink Assembly:
-
Direct bolt-on installation – no drilling or cutting required
-
Patent Pending Reverse Taper Mount – flip your draglink without altering the knuckle
-
Clears critical chassis components with precision engineering
-
Made in the USA
Ball Joints:
-
30mm 2.5-ton ball joints built specifically for the Jeep JK
-
Cold-headed medium carbon alloy steel ball studs = extreme impact toughness
-
Induction heat-treated for superior fatigue strength and off-road durability
-
Steel-on-steel bearings resist wear and tear in the harshest conditions
-
High-quality seals reduce grease leakage between service intervals
-
Fully greaseable for long-term reliability
Draglink Ends:
-
Dual-layer coating – E-coat + powder coat for lasting protection
-
E-coated external threads for long service life and corrosion resistance
-
Forged steel construction – heat-treated for buckling, impact, and fatigue strength
-
1¼” rolled threads provide up to 60% more strength than OE threads
-
Exclusive Reverse Pin Technology eliminates linkage flop without external braces
Adjuster Tube:
-
¼” thick wall 4130 Chromoly steel = maximum buckling strength
-
Clamp-style adjusters eliminate the risk of jam nut loosening
-
Right- and left-hand threads allow for easy adjustments while installed
-
E-coated internals for long-term corrosion protection
Important Fitment Notes
-
A minimum lift height of 3–3.5” is required, along with proper bump stop setup
-
Part #79017001 (Track Bar Relocation Bracket) is required to maintain proper geometry when flipping the draglink
-
Works with factory tapered knuckle and pitman arm holes – no insert or sleeve required
Vehicle Compatibility
-
Fits all 2007–2018 Jeep Wrangler JK models (Rubicon, Unlimited)
-
Left-hand drive only
Wheel Fitment
-
Minimum 17” wheels recommended
-
16” wheels with up to 4.5” backspacing may fit, but clearance is not guaranteed
Fastest, Easiest Draglink Flip on the Market
Don’t waste time modifying your factory knuckle. The YETI XD “No Drill” Top Mount Draglink gives you a clean, secure flip solution without compromises—perfect for JK owners looking to improve steering geometry and component strength with a true bolt-on solution.
Flip your draglink in minutes, upgrade your control, and hit the trail with confidence—only with YETI XD from STEER SMARTS.