Description
Our new Rebel Off Road 50" Windshield banner now available in 9 colorways.
Available in red, white, matte black, silver, green, blue, gold, sing-gray, and orange.
50" Length
3" Height
INSTALLATION INSTRUCTIONS:
What You’ll Need:
✔️ A clean, dry surface
✔️ Soapy water solution (a few drops of dish soap in a spray bottle of water)
✔️ A squeegee or credit card
✔️ Painter’s tape
✔️ A sharp blade (optional, for any trimming)
Application Steps:
1. Clean the Windshield
Before starting, make sure your windshield is completely clean and dry. Use glass cleaner to remove any dirt, grease, or residue.
2. Position the Decal
Hold the decal up to the windshield to find the best placement. Use painter’s tape to temporarily secure it along the top edge, acting as a hinge.
3. Peel the Backing Paper
Carefully lift the decal from one side and begin peeling the backing paper away, exposing the adhesive side. Try not to touch the sticky part too much.
4. Apply Using Soapy Water (Recommended for Large Decals)
Lightly mist the windshield with your soapy water solution—this allows for easier repositioning. Slowly lay the decal onto the glass while using a squeegee or credit card to press out air bubbles and excess water from the center outward.
5. Remove the Transfer Tape
Once the decal is fully applied and dry (this can take a few minutes to an hour, depending on temperature), slowly peel off the top transfer tape at a sharp angle. If any part lifts, press it back down and give it more time to adhere.
6. Final Touches
Check for bubbles—small ones should disappear over time. If needed, use a sharp blade to carefully pop and smooth them out.
✅ Pro Tips:
- Install in a cool, shaded area (avoid direct sunlight).
- Don’t rush—slow, even pressure is key!
- Let the decal set for 24 hours before washing your vehicle.
