G2 Axle & Gear is proud to introduce our new CORE 44 axle assemblies for 2007 and up Jeep JK Wranglers. This housing has additional caster built into it to accommodate lift kits of 6" and up. This will allow for better pinion angles while retaining proper caster settings.Utilizing the strongest and latest generation high pinion 8.8" Dana 44 gear design, we have developed a whole new housing to handle the heavy loads that would normally bend a stock Dana 30 or Rubicon Dana 44. Then we stuff this heavy duty axle housing full of the best aftermarket components available like lockers of your choice and G/2 USA made Placer Chromalloy 35 spline axle shafts for the strongest Dana 44 available.
JK High Pinion Front with 5.38 gear ratio and Auburn Ected
Utilizes new generation 8.8in. JK 44 ring & pinion with larger pinion shaft
USA Made 4340 Chromalloy 1.5in. 35 spline Placer axle shafts
Haevy duty Dana Spicer 5-7166X Axle U-Joints
Factory style flange pinion yoke
3Degrees extra axle caster for 6in. and up lifts
Massive forged inner C-ends
Integrated skid plates on lower control arm mounts
Heavy-duty 1/4in. laser cut brackets
Heavy duty 3in. diameter 5/16in. DOM tubes
Reinforcing ribs for added strength and protection
Uses metric Rubicon style carrier bearings
Heavy duty forged bearing caps
Spanner nuts for backlash adjustment
Heat-treated aluminum diff cover with cooling fins
Revolution Rear Axle Shafts for Jeep Wrangler JL are made from 4340 Chromoly steel and are precision-machined to OEM specifications.
The Revolution axle shafts come complete with bearings, seals, and...